Home › BODY › ENGINE HOOD / DOOR › BACK DOOR SUPPORT

BACK DOOR SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart .



1. REMOVE BACK DOOR DUMPER STAY SUB-ASSEMBLY LH


    B063577
  1. Remove the 2 bolts and damper stay from the door panel.

    HINT:
    While supporting the hood by hand, remove the hood support.

  1. Loosen the bolt and remove the damper stay from the vehicle body.