Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    I033101
  1. Inspect the light control switch continuity.

    1. Check that there is continuity between terminals at each switch position as shown in the chart.
      Switch operation
      Tester connection
      Specified condition
      OFF
      -
      No continuity
      TAIL
      14 - 6
      Continuity
      HEAD
      13 - 16 - 14
      Continuity
      AUTO
      16 - 12
      Continuity

  1. Inspect the headlight dimmer switch continuity.

    1. Check that there is continuity between terminals at each switch position as shown in the chart.
      Switch operation
      Tester connection
      Specified condition
      FLASH
      7 - 8 - 16
      Continuity
      LOW BEAM
      16 - 17
      Continuity
      HI BEAM
      7 - 16
      Continuity

  1. Inspect the turn signal switch continuity.

    1. Check that there is continuity between terminals at each switch position as shown in the chart.
      Switch operation
      Tester connection
      Specified condition
      Right turn
      2 - 3
      Continuity
      Neutral
      -
      No continuity
      Left turn
      1 - 2
      Continuity

  1. Inspect the front fog light switch continuity.

    1. Check that there is continuity between terminals at each switch position as shown in the chart.
      Switch operation
      Tester connection
      Specified condition
      OFF
      -
      No continuity
      ON
      10 - 11
      Continuity