Home › DRIVE LINE · DIFFERENTIAL › 1GR-FE DIFFERENTIAL VACUUM ACTUATOR (for 4WD)

1GR-FE DIFFERENTIAL VACUUM ACTUATOR (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY


    F043678E06
  1. Measure the resistance between the terminals 1 to 2.

    Standard resistance:
    0.1 to 100 Ω

  1. Measure the resistance between the terminals 1 or 2 and body ground.

    Standard resistance:
    5 MΩ or more

    If the resistance value is not as specified, replace the differential vacuum actuator assembly.

  1. Apply battery positive voltage between the terminal 1 to 2, and check the actuator operation by sound, actuator status and continuity between the terminal 3 to 4, 5 to 4 and 6 to 4.

    Battery voltage applied terminal
    3 to 4 terminals continuity
    5 to 4 terminals continuity
    6 to 4 terminals continuity
    Actuator status
    1 (+) - 2 (-)
    Continuity
    Continuity
    No continuity
    Connected
    1 (-) - 2 (+)
    No continuity
    No continuity
    Continuity
    Disconnected