Home › DRIVE LINE ยท DIFFERENTIAL › 1GR-FE DIFFERENTIAL VACUUM ACTUATOR (for 4WD)

1GR-FE DIFFERENTIAL VACUUM ACTUATOR (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY REAR
  1. Remove the 6 bolts and engine under cover assembly rear.



2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and No. 1 engine under cover sub-assembly.



3. REMOVE FRONT DIFFERENTIAL DRAIN PLUG


4. DRAIN DIFFERENTIAL OIL


    D025304E03
  1. Stop the vehicle on a level place.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is within 5mm (0 to 0.20 in.) of the bottom of the filler plug opening.

    NOTICE:
    1. Excessively large or small quantities of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

    HINT:
    If necessary, fill the rear differential carrier assembly with hypoid gear oil.

    Oil grade:
    Hypoid gear oil API GL-5
    Recommended viscosity:
    Above -18°C (0°F) SAE 90
    Below -18°C (0°F) SAE 80W or 80W-90

    Capacity:
    Front differential carrier assembly:
    1.35 to 1.45 litters
    (1.43 to 1.53 US qts, 1.19 to 1.27 lmp. qts)
    Rear differential carrier assembly
    3.00 to 3.10 litters
    (3.17 to 3.27 US qts, 2.64 to 2.72 lmp. qts)

  1. Check for oil leakage if the oil level is low.

  1. Install the differential filler plug and a new gasket.

    Torque:
    Front differential carrier assembly:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }
    Rear differential carrier assembly:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


    C098708E05
  1. Place matchmarks on the propeller shaft flange and differential.

  1. Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft assembly.



    C098709E04
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft assembly.



6. REMOVE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY


    C097020
  1. Remove the bolt and separate the front differential breather tube bracket.

  1. Support the front differential with a jack.

  1. Remove the No. 1 front differential mount nut.

  1. Remove the 2 front mounting bolts and 2 nuts.

  1. Disconnect the actuator hose and connector.

  1. Lower the jack.



    F043679
  1. Remove the 4 bolts and differential vacuum actuator assembly.