Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING VALVE AND TRANSMITTER

TIRE PRESSURE WARNING VALVE AND TRANSMITTER > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE REAR WHEEL


3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Remove the valve core, cap, and release air from the tire.

  1. After ensuring that air is sufficiently released, remove the nut, washer that is used to fix the tire pressure monitor valve sub-assembly and drop the sensor inside the tire.



    F046444E01
  1. After dropping the tire pressure monitor valve sub-assembly into the tire, disengage the bead using the shoe of the tire remover.

    NOTICE:
    Be careful not to damage the tire pressure monitor valve sub-assembly due to interference between the sensor and tire bead.

  1. Remove the bead on the upper side as in usual operation.

  1. Take out the sensor from the tire and remove the bead on the lower side as in usual operation.

  1. Remove the inner grommet from the tire pressure monitor valve sub-assembly.

    HINT:
    Check that no crack or damage is identified on the grommet. If so, replace the grommet together with the washer and nut.