Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL
  1. Disconnect the negative terminal.



2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH


    B062748E01
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board RH.



4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2


    B062749E01
  1. Remove the screw <E>.

  1. Disengage the 3 clips and remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE TIRE PRESSURE WARNING ECU


    F046450
  1. Disconnect the connector.

  1. Remove the 2 screws and tire pressure monitor ECU.