Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure monitor ECU. It also supplies the power to the tire pressure monitor receiver via the ECU.

WIRING DIAGRAM


F045866E01


INSPECTION PROCEDURE

1.CHECK BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
REPLACE BATTERY
OK


2.CHECK FUSE (ECU-IG)


    F045867E01
  1. Remove the ECU-IG fuse from driver side J/B.

  1. Measure the resistance of the ECU-IG fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK TIRE PRESSURE WARNING ECU


    F045868E03
  1. Remove the tire pressure monitor ECU with connectors being connected.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    T16-2 (IG) - T16-11 (GND)
    10 to 14 V



NG
Go to step 4
OK

REPLACE TIRE PRESSURE WARNING ECU 

4.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - BODY GROUND)


    F045860E06
  1. Disconnect the tire pressure monitor ECU T16 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-11 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU