Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the ECU detects trouble, it lights the tire pressure warning light while at the same time prohibiting tire pressure monitor. At this time, the ECU records a DTC in memory.
Connect terminals TC and CG of the DLC3 to make the tire pressure warning light blink and output the DTC.

WIRING DIAGRAM


F050629E01


INSPECTION PROCEDURE

1.CHECK TIRE PRESSURE WARNING LIGHT CIRCUIT


    F045860E05
  1. Disconnect the tire pressure monitor ECU T16 connector.

  1. Connect terminal IND of the tire pressure monitor ECU and body ground.

  1. Turn the ignition switch to the ON position.

  1. Check that the tire pressure warning light goes off.

    OK:
    Tire pressure warning light goes off



NG
Go to step 2
OK

REPLACE TIRE PRESSURE WARNING ECU 

2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - COMBINATION METER)


    F045860E05
  1. Remove the combination meter assembly.

  1. Disconnect the combination meter assembly C8 connector.



    F045865E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-6 (IND) - C8-1
    Below 1 Ω
    T16-6 (IND) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER POWER SOURCE CIRCUIT)


    F046789E01
  1. Disconnect the combination meter assembly C10 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    C10-15 - C8-1
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK COMBINATION METER (TIRE PRESSURE WARNING LIGHT)


    F045864E01
  1. Connect the combination meter assembly C8 and C10 connectors.



    F045853E01
  1. Check warning light on the combination meter assembly.

    1. Check that the tire pressure warning light comes on when battery voltage is applied to the terminals as shown in the table below.
      Warning Light
      Battery Positive
      Battery Negative
      Tire pressure
      C10-15
      C8-1

      OK:
      Tire pressure warning light comes on.



NG
REPLACE COMBINATION METER
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE