Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C2176/76
DTC is stored when either of the following is detected:
  1. EEPROM data is invalid to use.
  2. Terminal RF5V is short to ground.
  1. Tire pressure monitor receiver assembly
  2. Tire pressure monitor ECU

WIRING DIAGRAM


F045862E01


INSPECTION PROCEDURE

HINT:
Set the tire pressure to the specified value.

1.CHECK TIRE PRESSURE WARNING RECEIVER


    F045861E03
  1. Disconnect the tire pressure monitor receiver assembly T17 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    T17-4 (GND) - T17-5 (+5V)
    4.5 to 5.5 V



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RECEIVER - TIRE PRESSURE WARNING ECU)


    F045860E02
  1. Disconnect the tire pressure monitor receiver assembly T17 connector and tire pressure monitor ECU T16 connector.



    F045861E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-7 (RDA) - T17-1 (RDA)
    Below 1 Ω



OK
Go to step 5
NG


3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RECEIVER - TIRE PRESSURE WARNING ECU)


    F045860E03
  1. Disconnect the tire pressure monitor receiver assembly T17 connector and tire pressure monitor ECU T16 connector.



    F045861E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-7 (RDA) - T17-1 (RDA)
    Below 1 Ω
    T16-8 (RF5V) - T17-5 (+5V)
    Below 1 Ω
    T16-16 (GND2) - T17-4 (GND)
    Below 1 Ω
    T16-7 (RDA) - Body ground
    10 kΩ or higher
    T16-8 (RF5V) - Body ground
    10 kΩ or higher
    T16-16 (GND2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK POWER SOURCE CIRCUIT


NG
REPAIR OR REPLACE POWER SOURCE CIRCUIT
OK


5.REPLACE TIRE PRESSURE WARNING RECEIVER

HINT:
Perform the inspection using parts from a normal vehicle when possible.


NEXT


6.CHECK DTC
  1. Check DTC.

    OK:
    DTC is not output.



NG
REPLACE TIRE PRESSURE WARNING ECU
OK

END