Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2191/91    Vehicle Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure monitor ECU receives a speed signal from the combination meter. This DTC is stored upon entering the test mode but erased when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The DTC is output only in the test mode.

DTC No.
DTC Detection Condition
Trouble Area
C2191/91
Speed sensor circuit malfunction.
  1. Vehicle speed sensor
  2. Combination meter assembly
  3. Tire pressure monitor ECU

WIRING DIAGRAM


F045874E01


INSPECTION PROCEDURE

1.READ VALUE OF INTELLIGENT TESTER

HINT:
When not using the intelligent tester, go to step 2.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position, and push the intelligent tester main switch ON.

  1. Select the item below in the DATA LIST, and read its value displayed on the intelligent tester.

    TIRE PRESSURE:

    Item
    Normal Condition
    VEHICLE SPEED
    Actual vehicle speed

  1. Check that the values indicated on the tester and the combination meter are the same.

    OK:
    Indicate actual speed



OK
REPLACE TIRE PRESSURE WARNING ECU
NG


2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - COMBINATION METER)


    F045860E04
  1. Disconnect the combination meter assembly C9 connector and tire pressure monitor ECU T16 connector.



    F045875E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-3 (SPD) - C9-5
    Below 1 Ω
    T16-3 (SPD) - Body ground
    10 kΩ higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TIRE PRESSURE WARNING ECU


    C139142E01
  1. Remove the tire pressure monitor ECU with connectors still connected.

  1. Check voltage.

    1. Shift the shift lever to neutral.

    2. Jack up one of the front wheels.

    3. Turn the ignition switch to the ON position.

    4. Measure voltage between terminals SPD and GND of the tire pressure monitor ECU when the front wheel is turned slowly.

      OK:
      Voltage is generated intermittently.



NG
REPLACE COMBINATION METER
OK

REPLACE TIRE PRESSURE WARNING ECU