Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TEST MODE PROCEDURE

for Preparation Click here



TEST MODE CHECK

HINT:
  1. When entering the test mode, the tire pressure monitor ECU sets all the test DTCs first.
    After completing the test mode for each inspection item, the DTCs that are determined normal by the tire pressure monitor ECU will be erased.
    The DTCs for other inspection items may not be erased when only a certain signal is inspected.
  2. When the test mode returns back to the normal mode, all the test DTCs will be erased.



    A066288E04
  1. Procedure for Test Mode.

    1. Make sure that the ignition switch is off.

    2. Connect the intelligent tester to DLC3.

    3. Turn the ignition switch to the ON position.



    4. Perform the test mode (SIGNAL CHECK) procedure.


      F045857

    5. After completing the input signal check, disconnect the tester and turn the ignition switch off.

      DTC of Tire Pressure Warning System test mode function:
      1. If a malfunction code is displayed during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to the "See Page" in the DTC chart (Click here).

        DTC No.
        Detection Item
        Trouble Area
        C2181/81
        Transmitter ID1 not received
        1. Tire pressure monitor receiver assembly
        2. Each tire pressure monitor valve sub-assembly
        3. Tire pressure monitor ECU
        4. Wire harness
        C2182/82
        Transmitter ID2 not received
        1. Tire pressure monitor receiver assembly
        2. Each tire pressure monitor valve sub-assembly
        3. Tire pressure monitor ECU
        4. Wire harness
        C2183/83
        Transmitter ID3 not received
        1. Tire pressure monitor receiver assembly
        2. Each tire pressure monitor valve sub-assembly
        3. Tire pressure monitor ECU
        4. Wire harness
        C2184/84
        Transmitter ID4 not received
        1. Tire pressure monitor receiver assembly
        2. Each tire pressure monitor valve sub-assembly
        3. Tire pressure monitor ECU
        4. Wire harness
        C2185/85
        Transmitter ID5 not received
        1. Tire pressure monitor receiver assembly
        2. Each tire pressure monitor valve sub-assembly
        3. Tire pressure monitor ECU
        4. Wire harness
        C2191/91
        Vehicle speed signal error
        1. Combination meter assembly
        2. Vehicle speed sensor
        3. Tire pressure monitor ECU
        4. Wire harness