Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


WIRING DIAGRAM


E116279E01


INSPECTION PROCEDURE

1.INSPECT FUSE
  1. Check the AM2 fuse in the engine room R/B.

    Standard resistance:
    Below 1 Ω

  1. Check the GAUGE fuse in the driver side J/B.

    Standard resistance:
    Below 1 Ω

  1. Check the DOME fuse in the engine room R/B.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT COMBINATION METER ASSEMBLY


    E113267E01
  1. Disconnect the C10 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    C10-16 (+B) - Body ground
    Always
    10 to 14 V
    C10-15 (IGN2) - Body ground
    Ignition switch ON
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    C10-13 (E/G GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY