Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Speedometer Malfunction

for Preparation Click here


WIRING DIAGRAM


E110183E11


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ABS & TRACTION ACTUATOR ASSEMBLY)


    A133752E01
  1. Disconnect the S28 and C9 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S28-12 (SP1) - C9-4 (SP INPUT)
    Always
    Below 1 Ω
    S28-12 (SP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT COMBINATION METER ASSEMBLY


    A133753E01
  1. Reconnect the C9 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    S28-12 (SP1) - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPLACE COMBINATION METER ASSEMBLY
OK


3.INSPECT COMBINATION METER ASSEMBLY


    E113265E01
  1. Check the input signal waveform.

    1. Remove the combination meter assembly.

    2. Connect the oscilloscope to terminal C9-4 and body ground.

    3. Start the engine.



    4. A005135E07
    5. Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Tool setting
      5 V/DIV., 20 ms/DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12.4 mph)

      HINT:
      As vehicle speed increases, the cycle of the signal waveform narrows.



NG
GO TO BRAKE CONTROL SYSTEM
OK

REPLACE COMBINATION METER ASSEMBLY