Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


WIRING DIAGRAM


E116115E01


INSPECTION PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY


    E113265E04
  1. Disconnect the C9 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    C9-12 (D SEAT BELT INPUT) - Body ground
    Seat belt is unfastened
    Below 1 Ω
    C9-12 (D SEAT BELT INPUT) - Body ground
    Seat belt is fastened
    10 kΩ or higher



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY 

2.INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


    I045351E01
  1. Disconnect the B15 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B15-3 - B15-4
    Seat belt is unfastened
    Below 1 Ω
    B15-3 - B15-4
    Seat belt is fastened
    10 kΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR