Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Front Passenger Side Seat Belt Warning Light Malfunction

for Preparation Click here


WIRING DIAGRAM


I045360E01


INSPECTION PROCEDURE

1.SYSTEM CHECK (INDICATOR CHECK)


    H040065E28
  1. Disconnect the A32 connector.

  1. Check the operation of the warning light according to the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    No connection
    Ignition switch ON
    Warning light OFF
    A32-2 (PBEW) - Body ground
    Ignition switch ON
    Warning light Blinks



NG
Go to step 3
OK


2.SYSTEM CHECK (INDICATOR CHECK)
  1. Connect the A32 connector.

  1. Check the operation of the warning light according to the table below.

    Standard:
    Condition
    Bulb Condition
    Result
    Ignition switch ON (Passenger does not sit on)
    OFF
    OK
    Ignition switch ON (Passenger sits on)
    Blinks
    OK
    Ignition switch ON (Passenger sits on and seat belt is fastened)
    OFF
    OK
    Ignition switch ON (Passenger sits on and seat belt is unfastened)
    Blinks
    OK

    Check with the auto cut off switch in the AUTO position (w/ airbag cut off switch).



NG
GO TO AIRBAG SYSTEM
OK

REPLACE COMBINATION METER ASSEMBLY 

3.CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY - COMBINATION METER ASSEMBLY)


    I045389E02
  1. Disconnect the A32 and C9 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A32-2 (PBEW) - C9-13 (P SEAT BELT INPUT)
    Always
    Below 1 Ω
    C9-13 (P SEAT BELT INPUT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - PASSENGER SEAT BELT WARNING LIGHT)


    I038356E01
  1. Disconnect the D3 and C9 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D3-3 (PBEW) - C9-18 (P SEAT BELT OUTPUT)
    Always
    Below 1 Ω
    D3-3 (PBEW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT PASSENGER SEAT BELT WARNING LIGHT


    I038357E01
  1. Disconnect the D3 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D3-2 (PBEW) - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY