Home › DRIVE LINE ยท DIFFERENTIAL › 2UZ-FE FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)

2UZ-FE FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT BACKLASH DIFFERENTIAL RING GEAR AND DIFFERENTIAL DRIVE PINION


    R012683E03
  1. Using SST and a dial indicator, measure the ring gear backlash.

    SST
    09564-32011  

    Backlash:
    0.13 to 0.18 mm (0.0051 to 0.0071 in.)

    If the backlash is not within the specification, adjust or repair the side bearing preload as necessary.



2. INSPECT DIFFERENTIAL DRIVE PINION PRELOAD


    FA01158
  1. Using a torque wrench, measure the preload of the backlash between the drive pinion and ring gear.

    Torque:
    0.49 to 0.78 N*m{ 5 to 8 kgf*cm , 4.3 to 6.9 in.*lbf }

    If necessary, disassemble and inspect the differential assembly.



3. INSPECT TOTAL PRELOAD
  1. Using a torque wrench, measure the preload with the teeth of the drive pinion and ring gear in contact.

    Total preload (at starting):
    Drive pinion preload plus 0.25 to 0.45 N*m (2.5 to 4.6 kgf*cm, 2.2 to 4.0 in.*lbf)

    If necessary, disassemble and inspect the differential.