Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (BODY ECU)

B062230E01

  1. Disconnect the B6 J/B connector.

  2. Disconnect the 1B, 1C, 1E and 1H J/B connectors.

  3. Check the voltage or continuity of each terminal of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring
    Condition
    Specified Condition
    KSW (B6-14) - Body ground
    G-Y - Body ground
    No key in ignition key cylinder → Key inserted
    10 kΩ or higher
    BDR1 (1E-9) - Body ground
    G-W - Body ground
    Always
    10 to 14 V
    BECU (1B-4) - Body ground
    W-R - Body ground
    Always
    10 to 14 V
    SIG (1C-2) - Body ground
    L-Y - Body ground
    Ignition switch ON
    10 to 14 V
    ACC (1D-5) - Body ground
    W-G - Body ground
    Ignition switch ON
    10 to 14 V
    GND1 (1H-2) - Body ground
    W-B - Body ground
    Always
    Below 1 Ω
    GND2 (1H-2) - Body ground
    W-B - Body ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  4. Reconnect the B6 J/B connector.

  5. Reconnect the 1B, 1C, 1D, 1E and 1H J/B connectors.

  6. Check the voltage of each terminal of the connectors.

    Symbols (Terminal No.)
    Wiring
    Condition
    Specified Condition
    RDA (B5-4) - Body ground
    L-R - Body ground
    Ignition switch OFF, no key in ignition key cylinder, all doors closed and transmitter switch OFF → ON
    Below 1 V → 6 V → Below 1 V
    DCTY (B5-23) - Body ground
    R-B - Body ground
    Driver's door CLOSED → OPEN
    10 to 14 V → Below 1 V
    PCTY (B5-24) - Body ground
    R-Y - Body ground
    Passenger's door CLOSED → OPEN
    10 to 14 V → Below 1 V
    RLCY (B5-11) - Body ground
    P-B - Body ground
    Rear door LH CLOSED → OPEN
    10 to 14 V → Below 1 V
    RRCY (B5-12) - Body ground
    P-L - Body ground
    Rear door RH CLOSED → OPEN
    10 to 14 V → Below 1 V
    HAZ (1J-14) - Body ground
    W - Body ground
    Answer-back OFF → Answer-back ON
    Pulse generation
    BZR (1B-10) - Body ground
    P-B - Y-B
    Wireless buzzer OFF → ON
    Pulse generation
    If the result is not as specified, the J/B assembly (body ECU) may have a malfunction.