Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL

HINT:
Click here.



2. REMOVE STEERING WHEEL COVER LOWER NO. 2


3. REMOVE STEERING WHEEL COVER LOWER NO. 3


4. REMOVE STEERING PAD


    F043322
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042354
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screw driver, disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE CRUISE CONTROL MAIN SWITCH


    E062033
  1. Disconnect the connector.



    E062034
  1. Remove the 2 screws and cruise control main switch.