Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a ground short is detected in terminal RDA or PRG.

DTC No.
DTC Detection Condition
Trouble Area
B1242
Ground short in terminal RDA or PRG
  1. Door control receiver
  2. Wire Harness
  3. Instrument panel J/B assembly (Body ECU)

WIRING DIAGRAM


B062222E01


INSPECTION PROCEDURE

1.CHECK DOOR CONTROL RECEIVER
  1. Check that the wireless system when a new or normal door control receiver is installed.

  1. Check that no DTC is output.



OK
REPLACE DOOR CONTROL RECEIVER
NG


2.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BODY ECU)


    B062225E02
  1. Disconnect the D7 receiver connector.

  1. Disconnect the B5 J/B connector.

  1. Check the continuity between the wire harness side connectors.

    Standard resistance:
    Symbols (Terminal No.)
    Specified Condition
    RDA (D7-2) - RDA (B5-4)
    Below 1 Ω
    PRG (D7-3) - PRG (B5-3)
    Below 1 Ω

  1. Check the continuity between the D7 receiver connector B5 J/B connector and body ground.

    Standard resistance:
    Symbols (Terminal No.)
    Specified Condition
    RDA (D7-2) or RDA (B5-4) - Body ground
    10 kΩ or higher
    PRG (D7-3) or PRG (B5-3) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY