Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR W/MOTOR LOCK ASSEMBLY LH


    B056800E02
  1. Apply battery voltage and inspect operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock

    If the operation is not as specified, replace the door lock assembly.

  1. Inspect the position switch continuity.

    Standard resistance:
    Terminal No.
    Door Lock Position
    Specified Condition
    6 - 9
    Lock
    10 kΩor higher
    6 - 9
    Unlock
    Below 1 Ω

    If the continuity is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR W/MOTOR LOCK ASSEMBLY RH


    B056799E02
  1. Apply battery voltage and inspect operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock

    If operation is not as specified, replace the door lock assembly.

  1. Inspect the position switch continuity.

    Standard resistance:
    Terminal No.
    Door Lock Position
    Specified Condition
    6 - 9
    Lock
    10 kΩor higher
    6 - 9
    Unlock
    Below 1 Ω

    If the continuity is not as specified, replace the door lock assembly.