Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2221    Jam Protection Pulse Sensor Circuit on Back Door

for Preparation Click here


DESCRIPTION

The back door ECU monitors the condition of the power window motor and detects the position of the door glass by using pulse signals output from the 2 pulse sensors in the power window motor.

DTC No.
DTC Detection Condition
Suspected Part
B2221
  1. PLS pulse sensor circuit malfunction
  2. PLS2 pulse sensor circuit malfunction
  3. Pulse direction is opposite to motor rotating direction (Short circuit between PLS and PLS2)
  4. PLS and PLS2 pulse sensors circuit malfunction
  5. Fully closed position is misaligned
  1. Power window regulator motor assembly LH (Back door)
  2. Wire harness

FAIL-SAFE

If the pulse sensor in the back door power window motor malfunctions (DTC B2221 is output), the power window functions will be restricted:
  1. The AUTO UP/ DOWN function is disabled.
  2. The MANUAL DOWN function via the transmitter is disabled.
  3. The MANUAL UP/DOWN function via the back door power window switch can be performed (the ignition switch ON).
  4. The MANUAL UP/DOWN function via the back door lock key cylinder can be performed (the ignition switch ON).

WIRING DIAGRAM


B062902E07


INSPECTION PROCEDURE

1.RESET POWER WINDOW REGULATOR MOTOR ASSEMBLY
  1. Turn the ignition switch ON.

  1. Open the back door glass.

  1. Press the back door power window switch until the door glass is fully closed, and continue to hold the switch 1 second more even after the door glass is fully closed.

  1. Check that the AUTO UP/DOWN function operates normally.



OK
END
NG


2.CHECK WIRE HARNESS (BACK DOOR ECU - WINDOW MOTOR) (BACK DOOR ECU - BODY GROUND)


    B062905E01
  1. Disconnect the B9 ECU connector.

  1. Disconnect the B11 motor connector.

  1. Check the continuity between the wire harness side connectors.

    Standard:
    Terminal No.
    Specified Condition
    B9-23 ←→ B11-3
    Continuity
    B9-17 ←→ B11-2
    Continuity
    B9-16 ←→ B11-6
    Continuity
    B9-11 ←→ B11-1
    Continuity

  1. Check the continuity between the B9 ECU connector and the body ground.

    Standard:
    Terminal No.
    Specified Condition
    B9-11 ←→ Body ground
    No continuity
    B9-16 ←→ Body ground
    No continuity
    B9-17 ←→ Body ground
    No continuity



OK
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY
NG

REPAIR OR REPLACE HARNESS AND CONNECTOR