Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Heater Relay Circuit

for Preparation Click here


DESCRIPTION

The heater relay is switched on by signals from the A/C amplifier. It supplies power to the blower motor.

WIRING DIAGRAM


I045743E01


INSPECTION PROCEDURE

1.CHECK FUSE (HTR)


    F043247E03
  1. Remove the HTR fuse from the engine room R/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    HTR fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (HTR)
OK


2.INSPECT HEATER BLOWER MOTOR RELAY


    E032993
  1. Remove the heater blower motor relay from the engine room R/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    When battery voltage applied to terminals 1 and 2
    Below 1 Ω
    3 - 4
    Always
    Below 1 Ω
    3 - 4
    When battery voltage applied to terminals 1 and 2
    10 kΩ or higher



NG
REPLACE HEATER BLOWER MOTOR RELAY
OK


3.CHECK HARNESS AND CONNECTOR (HEATER BLOWER MOTOR RELAY - BATTERY)


    I033590E01
  1. Remove the heater blower motor relay assembly from the engine room R/B.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Ignition switch ON
    10 to 14 V
    5 - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (HEATER BLOWER MOTOR RELAY - BODY GROUND)


    I033590E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    4 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (HEATER BLOWER MOTOR RELAY - AIR CONDITIONING AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the heater blower motor relay and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE