SLIDING ROOF SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT WINDOW LOCK SWITCH |
Check that operation of the door glasses except the driver side door glass, the back door glass and the roof glass are disabled when the window lock switch of the power window master switch is pressed.
Check that the door glasses, the back door glass and the roof glass can be operated when the window lock switch is pressed again.
| 2. INSPECT AUTO SLIDE-OPEN/CLOSE FUNCTION |
Check that the sliding roof switch can operate the roof glass as follows while the tilt-UP / DOWN function is not operating:
| Condition | Switch | Switch Operation | Roof Glass |
| SLIDE OPEN | Pressed more than 0.3 sec. | Fully open |
| TILT UP | Fully closed |
| 3. INSPECT AUTO TILT UP/DOWN FUNCTION |
Check that the sliding roof switch can operate the roof glass as follows while the slide-OPEN/CLOSE function is not operating:
| Condition | Switch | Switch Operation | Roof Glass |
| TILT UP | Pressed more than 0.3 sec. | Fully tilted up |
| SLIDE OPEN | Fully closed |
| 4. INSPECT SLIDING ROOF OPERATION FUNCTION AFTER IGNITION SWITCH OFF |
Under both of the following conditions, check that the door glasses, the back door glass and the roof glass can be operated even after the ignition switch is turned OFF:
| 5. CHECK DEFLECTOR OPERATION |
Check deflector AUTO operation.
Run the vehicle with the sliding roof fully open, and check that the deflector lowers (AUTO DOWN) as the vehicle speed increases and rises (AUTO UP) as the vehicle speed decreases.
Check that the deflector lowers according to the vehicle speeds when the sliding roof has been fully opened while the vehicle is running.
Check that the sliding roof automatically tilts UP/DOWN depending on the vehicle speed.
Conditions that enable the sliding roof to automatically tilt DOWN:
Conditions that enable the sliding roof to automatically tilts UP:
| 6. INSPECT JAM PROTECTION FUNCTION |
![]() |
When the slide-OPEN/CLOSE function is operating:
Check that the roof glass opens by approximately 200 mm (7.87 in.) right when something gets caught between the vehicle body and the roof glass during roof glass operation.
![]() |
When the tilt-UP/DOWN function is operating:
Check that the roof glass fully tilts up when something gets caught between the vehicle body and the roof glass during roof glass operation.
| 7. INSPECT FAIL-SAFE FUNCTION |
If the roof glass is not closed because the jam protection function operates improperly, perform following operation. Then, you can close the roof glass using the manual operation function.
Press the sliding roof switch on TILT UP side and hold it for 10 seconds after the jam protection function operates. Then you can use the manual operation function.