Home › BODY ELECTRICAL › OTHER SYSTEM › VOLTAGE INVERTER

VOLTAGE INVERTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VOLTAGE INVERTER

HINT:
Remove interior parts so that the voltage inverter can be seen.



    E117968E04
  1. Disconnect the voltage inverter connector.

  1. Measure the voltage according to the values in the table below.

    Input voltage:

    Tester connection
    Condition
    Specified condition
    IG (V9-1) - E (V9-4)
    Ignition switch ON
    10 to 16 V
    GND (V9-4) - Body ground
    Always
    Below 1 V

    HINT:
    If the result is not as specified, repair or replace harness or connector.



    E113506E04
  1. Reconnect the voltage inverter connector.

  1. Measure the voltage according to the values in the table below.

    Output voltage:

    Tester connection
    Condition
    Specified condition
    AC1 (V9-3) - AC2 (V9-7)
    Ignition switch ON
    Main switch ON
    AC 115 V

    HINT:
    If the result is not as specified, replace the voltage inverter.