Home › ENGINE ยท 2UZ-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL EXHAUST PIPE ASSEMBLY FRONT
  1. Install a new gasket and front pipe to exhaust manifold.

  1. Install the exhaust pipe front with 2 nuts.

    Torque:
    62 N*m{ 633 kgf*cm , 46 ft.*lbf }



2. INSTALL NO. 2 EXHAUST FRONT PIPE ASSEMBLY
  1. Install the 2 new gaskets and the front pipe to exhaust manifold.

  1. Install the exhaust pipe front with 2 bolts and 2 nuts.

    Torque:
    Nut:
    62 N*m{ 633 kgf*cm , 46 ft.*lbf }
    Bolt:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }



3. INSTALL EXHAUST PIPE ASSEMBLY CENTER


    A072559E01
  1. Using vernier calipers, measure the free length to the compression spring.

    Minimum length:
    40.5 mm (1.5945 in.)

    If the free length is less than minimum, replace the compression spring.

  1. Install a new gasket on the exhaust pipe assembly front.

  1. Install the exhaust pipe assembly center with 2 bolts and 2 springs.

    Torque:
    43 N*m{ 440 kgf*cm , 32 ft.*lbf }



4. INSTALL EXHAUST PIPE ASSEMBLY TAIL
  1. Install a new gasket on the exhaust pipe center.

  1. Install the tail pipe with 2 bolts.

    Torque:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }



5. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Install heated oxygen sensor to exhaust pipe front.

    Torque:
    44 N*m{ 450 kgf*cm , 33 ft.*lbf }

  1. Connect the heated oxygen sensor connector.

    HINT:
    After installing heated oxygen sensor, check that sensor wire is not twisted. If it is twisted, remove the heated oxygen sensor and reinstall it.



6. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
  1. Install heated oxygen sensor to exhaust pipe front.

    Torque:
    44 N*m{ 450 kgf*cm , 33 ft.*lbf }

  1. Connect the heated oxygen sensor connector.

    HINT:
    After installing heated oxygen sensor, check that sensor wire is not twisted. If it is twisted, remove the heated oxygen sensor and reinstall it.



7. INSPECT EXHAUST GAS LEAKAGE