Home › ENGINE ยท 2UZ-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A067109
  1. Disconnect a heated oxygen sensor connector.

  1. Remove the heated oxygen sensor.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A067110
  1. Disconnect a heated oxygen sensor connector.

  1. Remove the heated oxygen sensor.



3. REMOVE EXHAUST PIPE ASSEMBLY TAIL
  1. Remove the 2 bolts, exhaust pipe support and tail pipe.



4. REMOVE EXHAUST PIPE ASSEMBLY CENTER
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the 4 exhaust pipe supports and exhaust pipe center.



5. REMOVE NO. 2 EXHAUST FRONT PIPE ASSEMBLY
  1. Remove the 2 bolts, 2 nuts and No. 2 exhaust front pipe assembly.



6. REMOVE EXHAUST PIPE ASSEMBLY FRONT
  1. Remove the 2 nuts and exhaust pipe assembly front.