ENGINE FRONT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
![]() |
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT PULLEY |
| 3. INSTALL FAN WITH FLUID COUPLING |
Put the fan pulley to the water pump.
Put the fan with fluid coupling and fan shroud together.
Temporarily install the 4 fluid coupling nuts.
Tighten the 2 fan shroud bolts and radiator reserve tank bolt.
Connect the reserve tank hose.
Fasten the 2 oil cooler hoses with the hose clamp.
| 4. INSTALL FAN AND GENERATOR V BELT |
![]() |
While turning the belt tensioner counterclockwise, align with its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.
Install the V-ribbed belt.
While turning the belt tensioner counterclockwise, remove the bar.
![]() |
If it is hard to install the V-ribbed belt, perform the following procedure.
Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.
| 5. FULLY TIGHTEN FAN WITH FLUID COUPLING |
Tighten the 4 fluid coupling bolts.
| 6. INSTALL RADIATOR SUPPORT SEAL UPPER |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
Connect the cable to the negative battery terminal.
| 8. CHECK FOR ENGINE OIL LEAKAGE |
| 9. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Install the engine under cover with the 4 bolts.
| 10. INSTALL V-BANK COVER |
Install the V-bank cover with the 2 nuts.