Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE V-BANK COVER


    A075593E01
  1. Remove the 2 nuts, then remove the V-bank cover.



3. REMOVE RADIATOR SUPPORT SEAL UPPER
  1. Remove the 11 clips and radiator support seal upper.



4. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and engine under cover.



5. LOOSEN FAN WITH FLUID COUPLING


    A076332
  1. Loosen the 4 fluid coupling bolts.



6. REMOVE FAN AND GENERATOR V BELT


    A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.



7. REMOVE FAN WITH FLUID COUPLING


    A076333
  1. Unfasten the hose clamp, and then separate the 2 oil cooler hoses from the fan shroud.

  1. Disconnect the radiator reserve tank hose.

  1. Remove the 2 fan shroud bolts and radiator reserve tank bolt.

  1. Remove the 4 fluid coupling nuts, and then remove the fan with fluid coupling and fan shroud together.

  1. Remove the fan pulley.



8. REMOVE CRANKSHAFT PULLEY

HINT:

SST
09213-54015   (91651-60855)
09330-00021  
09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05030)


9. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A076330
  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft. Wrap the tip of the screwdriver with tape.