OIL FILTER > INSTALLATION |
| 1. INSTALL OIL FILTER ASSEMBLY |
![]() |
Clean the oil filter contact surface on the oil filter mounting.
Lubricate the filter rubber gasket with clean engine oil.
Tighten the oil filter by hand until the rubber gasket contacts the seat of the filter mounting.
![]() |
Using SST, give it an additional 3/4 turn to set the filter.
| 2. ADD ENGINE OIL |
Fill with fresh engine oil.
| Drain and refill with oil filter change | 6.2 liters (6.5 US qts, 5.5 lmp. qts) |
| Drain and refill without oil filter change | 5.7 liters (6.0 US qts, 5.0 lmp. qts) |
| Dry fill | 7.1 liters (7.5 US qts, 6.2 lmp. qts) |
Reinstall the oil filler cap.
| 3. INSPECT ENGINE OIL LEAKS |
| 4. INSPECT ENGINE OIL LEVEL |
| 5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |