Home › ENGINE ยท 2UZ-FE › LUBRICATION › OIL FILTER

OIL FILTER > REMOVAL

for Preparation Click here


CAUTION:
  1. Prolonged and repeated contact with engine oil will cause the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
  2. Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil.
  3. Wash your skin thoroughly with soap and water, or use waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners, or solvents.
  4. For environmental protection, used oil and used oil filters must be disposed of only at designated disposal sites.



1. DRAIN ENGINE OIL


    A072683
  1. Remove the engine under cover seal No. 3.

  1. Remove the oil pan drain plug and drain the engine oil.

  1. Clean the oil pan drain plug and install a new gasket and it.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


3. REMOVE OIL FILTER ASSEMBLY


    A072684E01
  1. Using SST, remove the oil filter.

    SST
    09228-07501