Home › ENGINE ยท 2UZ-FE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY REAR


2. DRAIN ENGINE OIL


    A072683
  1. Remove the engine under cover seal No. 3.

  1. Remove the oil pan drain plug and drain the engine oil.

  1. Clean the oil pan drain plug and install a new gasket and it.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



3. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. Remove the radiator cap.



    A070279E01
  1. Remove the service hole cover from the engine under cover No. 1.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.



    A070477E01
  1. Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.



4. REMOVE OIL FILTER ASSEMBLY


    A072684E01
  1. Using SST, remove the oil filter.

    SST
    09228-07501  



5. REMOVE OIL COOLER ASSEMBLY
  1. Disconnect the 2 oil cooler hoses from oil cooler.

  1. Remove the union bolt, plate washer and the oil cooler.

  1. Remove the O-ring from the oil cooler.