Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1779/79    Crankshaft Position Sensor Circuit

DTC    C1797/97    Crankshaft Position Sensor Circuit

for Preparation Click here


DESCRIPTION

The suspension control ECU receives the engine speed signal from ECM.

DTC No.
DTC Detection Condition
Trouble Area
C1779/79
TACH signal is not sent to suspension control ECU, and the vehicle is driven for 10 sec. or more at the speed of 30 km/h or higher.
  1. Crankshaft position sensor
  2. Crankshaft position sensor circuit
  3. ECM
  4. Suspension control ECU

HINT:
When DTC C1797/97 is output, follow the same procedure as that of DTC1779/79.


WIRING DIAGRAM


F043231E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - ECM)
  1. Check for open and short circuit in the harness and the connector between the suspension control ECU and ECM (Click here).



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT ECM (TACH SIGNAL)


    I034219E17
  1. Remove the ECM with connectors being connected.

  1. Turn the ignition switch ON.

  1. Connect an oscilloscope to terminals E7-1 (TACH) and E6-1 (E1) of the ECM harness side connector.



    F044950E04
  1. With the engine idling, check the signal waveform.

    Standard:
    Signal waveform appears as shown in the illustration.

    HINT:
    As the engine speed becomes higher, the waveform cycle gets shorter.



NG
REPLACE ECM
OK

REPLACE SUSPENSION CONTROL ECU