Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

AIR SUSPENSION SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC is output when there is a short circuit between terminals TC and CG of DLC3.

WIRING DIAGRAM


F043237E01


INSPECTION PROCEDURE

1.CHECK DLC3 TERMINAL VOLTAGE (TC TERMINAL)


    B124401E92
  1. Turn the ignition switch to the ON position.

  1. Measure voltage between terminals TC and CG of DLC3.

    Standard voltage:
    10 to 14 V



OK
Go to step 3
NG


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
  1. Check for open and short circuit in the harness and the connector between terminal CG of DLC3 and body ground (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (DLC3 - SUSPENSION CONTROL ECU)
  1. Check for open and short circuit in the harness and the connector between terminal TC of DLC3 and the suspension control ECU (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU