Home › ENGINE ยท 1GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here


HINT:
If the thermostat was not installed, cooling efficiency would be harmed. Even if the engine tends to overheat, do not remove the thermostat.



1. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.



    A070279E01
  1. Remove the service hole cover from the engine under cover.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.



    A076320E02
  1. Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Remove the radiator cap.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.



2. REMOVE V-BANK COVER


    A075593E01
  1. Remove the 2 nuts, then remove the V-bank cover.



3. DISCONNECT RADIATOR OUTLET, NO.2 HOSE CLAMP OR CLIP


4. REMOVE WATER INLET WITH THERMOSTAT


    A076319
  1. Remove the 3 nuts, water inlet with thermostat and gasket.