THERMOSTAT > INSTALLATION |
| 1. INSTALL WATER INLET WITH THERMOSTAT |
Install a new gasket to the water inlet with thermostat.
Install the water inlet with thermostat with the 3 nuts.
| 2. CONNECT RADIATOR OUTLET, NO.2 HOSE CLAMP OR CLIP |
| 3. ADD ENGINE COOLANT |
Slowly fill the system with engine coolant.
Install the radiator cap securely.
Bleed the cooling system.
Open the heater water valve while warming up the engine.
Maintain the engine speed at 2,000 to 2,500 rpm and warm up the engine.
Stop the engine and wait until the coolant cools down.
Add coolant into the reservoir until the coolant level is FULL.
| 4. INSPECT ENGINE COOLANT LEAKAGE |
Fill the radiator with coolant and attach a radiator cap tester.
Pump it to 118 kPa (1.2 kgf/cm2 17.1 psi), then check for leakage.
| 5. INSTALL V-BANK COVER |
Install the V-bank cover with the 2 nuts.