RADIATOR > INSTALLATION |
| 1. INSTALL RADIATOR ASSEMBLY |
![]() |
Insert the tabs of the radiator support through the radiator service holes.
Install the radiator assembly with the 4 bolts.
| 2. INSTALL FAN SHROUD |
![]() |
Insert the tabs in the slots shown in the illustration, attach the fan shroud with the 2 bolts.
| 3. INSTALL RADIATOR RESERVE TANK ASSEMBLY |
Install the reserve tank with the 3 bolts.
Connect the reserve tank hose to the radiator.
| 4. ADD ENGINE COOLANT |
Slowly fill the system with engine coolant.
Install the radiator cap securely.
Bleed the cooling system.
Open the heater water valve while warming up the engine.
Maintain the engine speed at 2,000 to 2,500 rpm and warm up the engine.
Stop the engine and wait until the coolant cools down.
Add coolant into the reservoir until the coolant level is FULL.
| 5. INSPECT ENGINE COOLANT LEAKAGE |
Fill the radiator with coolant and attach a radiator cap tester.
Pump it to 118 kPa (1.2 kgf/cm2 17.1 psi), then check for leakage.