Home › SUSPENSION & AXLE › SUSPENSION CONTROL › HEIGHT CONTROL DRYER

HEIGHT CONTROL DRYER > INSTALLATION

for Preparation Click here



1. INSTALL HEIGHT CONTROL DRYER ASSEMBLY
  1. Install the bolt, the dryer and a new O-ring.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.

    Torque:
    29 N*m{ 300 kgf*cm , 21 ft.*lbf }

  1. Install the height control compressor assembly to the bracket with the 3 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

  1. Connect the connector.



2. CONNECT HEIGHT CONTROL TUBE NO. 2
  1. Coat 2 new O-rings with MP grease.

  1. Push the height control tube No. 2 in straight to connect it until the clip makes "click" sound.

    NOTICE:
    Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

  1. Install the holder.



3. INSTALL HEIGHT CONTROL FILTER
  1. Install the height control filter with the new 2 bolts.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect 2 new clips and 2 hoses.



4. INSTALL HEIGHT CONTROL COMPRESSOR COVER
  1. Install the height control compressor cover with 3 new clips.



5. CHECK AIR LEAK


  1. Check the connections of tube and parts for fluid leakage.


    C099149E01



6. INSTALL SPARE DISC WHEEL


7. INSTALL FUEL TANK FILLER PIPE PROTECTOR
  1. Install the fuel tank filler pipe protector with the 4 clips.



8. INSTALL REAR BUMPER


    B120263
  1. Install the rear bumper assembly with the 6 claws.



    B120262E01
  1. Install the 8 bolts and 4 screws.

    Torque:
    Bolt:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
    Screw:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the 2 clips.



9. INSTALL QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH


10. INSTALL REAR DISC WHEEL

Torque:
112 N*m{ 1,140 kgf*cm , 83 ft.*lbf }