Home › SUSPENSION & AXLE › SUSPENSION CONTROL › HEIGHT CONTROL RESERVOIR

HEIGHT CONTROL RESERVOIR > REMOVAL

for Preparation Click here



1. REMOVE SPARE DISC WHEEL


2. DISCONNECT HEIGHT CONTROL TUBE NO. 2
  1. Remove the holder.

  1. Spread the clip and slowly pull the height control tube No. 2 straight out.

  1. Remove the 2 O-rings.



3. DISCONNECT HEIGHT CONTROL TUBE NO. 6
  1. Using SST, disconnect the height control tube No. 6.

    SST
    09730-00010  

    NOTICE:
    Refer to PRECAUTION of removal and installation of the height control tube (Click here).

  1. Remove the 2 O-rings, the plate and the plug.



4. DISCONNECT HEIGHT CONTROL TUBE NO. 7
  1. Using SST, disconnect the height control tube No. 7.

    SST
    09730-00010  

    NOTICE:
    Refer to PRECAUTION of removal and installation of the height control tube (Click here).

  1. Remove the 2 O-rings, the plate and the plug.



5. REMOVE HEIGHT CONTROL RESERVOIR ASSEMBLY
  1. Remove the 2 bolts and the height control reservoir assembly.