Home › SUSPENSION & AXLE › SUSPENSION CONTROL › SUSPENSION CONTROL ECU

SUSPENSION CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure described for the LH side.



3. REMOVE COWL SIDE TRIM BOARD LH


    B062748E01
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board RH.



4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 1


    B062749E01
  1. Remove the screw <E>.

  1. Disengage the 3 clips and remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE INSTRUMENT PANEL FINISH PLATE


    B062751E01
  1. Remove the 4 screws <E>.

  1. Disengage the 2 claws and remove the instrument panel finish panel.



6. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER


    B062739E01
  1. Remove the 2 bolts <B>.

  1. Disengage the 2 claws and remove the instrument panel lower LH.



7. REMOVE INSTRUMENT PANEL LOWER LH


8. REMOVE SUSPENSION CONTROL ECU


    G020175
  1. Disconnect the 3 suspension control ECU connectors.

  1. Remove the 2 bolts and the suspension control ECU.