Home › SUSPENSION & AXLE › SUSPENSION CONTROL › HEIGHT CONTROL COMPRESSOR

HEIGHT CONTROL COMPRESSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY
  1. Install the 3 bushings to the height control compressor assembly.

  1. Install the bolt, the dryer and the new O-ring.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.

    Torque:
    29 N*m{ 300 kgf*cm , 21 ft.*lbf }

  1. Install the height control compressor assembly to the bracket with the 3 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

  1. Install the 3 clamps.

  1. Connect the connector.

  1. Connect the No. 1 hose with a new clip.



2. CONNECT HEIGHT CONTROL TUBE NO. 2
  1. Coat 2 new O-rings with MP grease.

  1. Push the height control tube No. 2 in straight to connect it until the clip makes "click" sound.

    NOTICE:
    Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

  1. Install the holder.



3. INSTALL HEIGHT CONTROL FILTER
  1. Install the height control filter with the new 2 bolts.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect 2 new clips and 2 hoses.



4. INSTALL HEIGHT CONTROL COMPRESSOR COVER
  1. Install the height control compressor cover with 3 new clips.



5. CHECK AIR LEAK


6. INSTALL SPARE DISC WHEEL


7. INSTALL FUEL TANK FILLER PIPE PROTECTOR
  1. Install the fuel tank filler pipe protector with the 4 clips.



8. INSTALL REAR BUMPER


    B120263
  1. Install the rear bumper assembly with the 6 claws.



    B120262E01
  1. Install the 8 bolts and 4 screws.

    Torque:
    Bolt:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
    Screw:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the 2 clips.



9. INSTALL QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH


10. INSTALL REAR DISC WHEEL

Torque:
112 N*m{ 1,140 kgf*cm , 83 ft.*lbf }