Home › SUSPENSION & AXLE › SUSPENSION CONTROL › HEIGHT CONTROL COMPRESSOR

HEIGHT CONTROL COMPRESSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR DISC WHEEL


2. REMOVE QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH


3. REMOVE REAR BUMPER


    B120262
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 8 bolts and 4 screws.



    B120263
  1. Disengage the 6 claws and remove the rear bumper assembly.



4. REMOVE FUEL TANK FILLER PIPE PROTECTOR
  1. Remove the 4 clips and the fuel tank filler pipe protector.



5. REMOVE SPARE DISC WHEEL


6. REMOVE HEIGHT CONTROL COMPRESSOR COVER
  1. Remove the 3 clips and the height control compressor cover.



7. REMOVE HEIGHT CONTROL FILTER
  1. Disconnect the 2 clips and the 2 hoses.

  1. Remove the 2 bolts and the height control filter.



8. DISCONNECT HEIGHT CONTROL TUBE NO. 2


    C099145
  1. Remove the holder.

  1. Spread the clip and slowly pull the height control tube No. 2 straight out.

    NOTICE:
    Do not remove the clip from the union except when replacing it.

  1. Remove the 2 O-rings.



9. REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY


    C099146
  1. Disconnect the connector.

  1. Remove the 3 clamps.



    C099147
  1. Remove the 3 bolts.

  1. Disconnect the clip and remove the No. 1 hose.



    C099148
  1. Remove the 3 bolts, the height control compressor and the dryer with the bracket.

  1. Remove the bolt, the dryer and the O-ring.

  1. Remove the 3 bushings from the height control compressor assembly.