Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1269    Theft Deterrent ECU Communication Stop

for Preparation Click here


DESCRIPTION

  1. DTC B1269 is output when the communication between the theft deterrent ECU and the body ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1269
Theft deterrent ECU communication stop
  1. Theft warning ECU assembly (Theft deterrent ECU)
  2. Wire harness

WIRING DIAGRAM


B065157E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (BODY ECU - THEFT DETERRENT ECU)


  1. Check the wire harness between the body ECU and theft deterrent ECU.



      B064050E01
    1. Disconnect the B6 and T5 connectors.

    2. Measure the resistance of the wire harness side connector.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      MPX3 (B6-26) - MPX1 (T5-31)
      Always
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT THEFT WARNING ECU ASSEMBLY


    B065163E01
  1. Disconnect the T5 connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    +B1 (T5-2) - Body ground
    Always
    10 to 14 V
    +B2 (T5-3) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT THEFT WARNING ECU ASSEMBLY


    B065163E01
  1. Disconnect the T5 connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E (T5-29) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY