Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1287    Back Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

  1. B1287 is output when the communication between the multiplex network door ECU back (back door ECU) and multiplex network body ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1287
Back door ECU communication stop
  1. Multiplex network door ECU back (Back door ECU)
  2. Wire harness

WIRING DIAGRAM


B065158E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (BODY ECU - BACK DOOR ECU)


  1. Check the wire harness between the body ECU and back door ECU.



      B064051E02
    1. Disconnect the B4 and B8 connectors.

    2. Measure the resistance of the wire harness side connector.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      MPX2 (B4-23) - MPX2 (B8-1)
      Always
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT MULTIPLEX NETWORK DOOR ECU (BACK DOOR ECU)


    B065162E01
  1. Disconnect the B8 connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    BECU (B8-5) - Body ground
    Always
    10 to 14 V
    BDR (B8-4) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MULTIPLEX NETWORK DOOR ECU (BACK DOOR ECU)


    B065162E01
  1. Disconnect the B8 connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    GND (B8-3) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX NETWORK DOOR ECU (BACK DOOR ECU)