Home › BODY › EXTERIOR › FRONT DOOR GLASS WEATHERSTRIP

FRONT DOOR GLASS WEATHERSTRIP > INSTALLATION

for Preparation Click here



1. INSTALL FRONT DOOR GLASS WEATHERSTRIP ASSEMBLY OUTER LH
  1. Install the glass weatherstrip with the claw and screw.



2. INSTALL FRONT DOOR WINDOW FRAME MOULDING REAR LH


3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


    B062419
  1. Install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the outer rear view mirror connector.



4. INSTALL FRONT DOOR SERVICE HOLE COVER LH


    B062414E01
  1. Apply butyl tape to the door, as shown in the illustration.

    Adhesive:
    Part No. 08850-00065, Butyl Tape Set or equivalent

  1. Install the service hole cover.

    Standard dimension:
    Area
    Measurement
    A
    6 mm (0.236 in.)
    B
    2 mm (0.079 in.)

    HINT:
    1. When installing the service hole cover, pull out the links and connectors through the service hole cover.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the sealing condition.



5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


6. INSTALL FRONT ARMREST ASSEMBLY LH


7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH


8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY