Home › BODY › EXTERIOR › FRONT DOOR GLASS WEATHERSTRIP

FRONT DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here


HINT:
On the RH side, use the same procedures as on the LH side.



1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B062415E01
  1. Using a screwdriver, remove the lower frame bracket garnish.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH


    B062416E02
  1. Using a screwdriver, disengage the 3 claws, and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT ARMREST ASSEMBLY LH


    B062417E01
  1. Disengage the claws, and remove the armrest from the trim board.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B062418E01
  1. Remove the 2 cushion rubbers.

  1. Remove the 2 screws and clips.

  1. Using a clip remover, remove the 11 clips.

  1. Remove the trim board upward.

    HINT:
    In order to prevent the door from being damaged, cover the parts indicated by arrow marks in the illustration with tape.



    H006127E01
  1. Disconnect the 2 cables from the inside handle as shown in the illustration.

  1. Remove the inner weatherstrip.

  1. Remove the 3 screws and power window master switch.



    B064057E01
  1. Using a screwdriver, disengage the 4 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the power mirror switch, as shown in the illustration.



6. REMOVE FRONT DOOR SERVICE HOLE COVER LH


    B065760E01
  1. Remove the front door service hole cover LH.

    NOTICE:
    Remove the remaining tape on the door side.



7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


    B062419
  1. Disconnect the outer rear view mirror connector.

  1. Remove the 3 nuts and outer rear view mirror.

    NOTICE:
    When the nuts are removed, the outer rear view mirror might drop and be deformed.



8. REMOVE FRONT DOOR WINDOW FRAME MOULDING REAR LH


    B065259E01
  1. Remove the screw.

  1. Using a heat light, heat the moulding to 40 to 60°C (104 to 140°F).

    NOTICE:
    Do not heat the moulding excessively.

  1. Disengage the 2 claws by pushing the moulding and remove the moulding.

    NOTICE:
    If reusing the moulding, take care not to damage the moulding.



9. REMOVE FRONT DOOR GLASS WEATHERSTRIP ASSEMBLY OUTER LH


    B062951E01
  1. Put protective tape under the glass weatherstrip assembly.

  1. Remove the screw.

  1. Using a screwdriver or moulding remover, disengage the claw and remove the glass weatherstrip.

    HINT:
    Tape the screwdriver tip before use.