Home › BODY › EXTERIOR › REAR DOOR GLASS WEATHERSTRIP

REAR DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here


HINT:
On the RH side, use the same procedures as on the LH side.



1. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR


2. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH


    B062416E03
  1. Using a screwdriver, disengage the 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the inside handle bezel.



3. REMOVE REAR ARMREST ASSEMBLY LH


    B062417E01
  1. Disengage the 4 claws, remove the armrest assembly.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B062434E01
  1. Remove the cushion rubbers.

  1. Remove the 2 screws.

  1. Using a clip remover, disengage the 12 clips, remove the 12 clips.

  1. Remove the trim board upward.

    HINT:
    In order to prevent the door from being damaged, cover the parts indicated by arrow marks in the illustration with tape.



    H006127E03
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the trim board.

  1. Remove the inner weatherstrip.



5. REMOVE REAR DOOR WINDOW FRAME MOULDING FRONT LH


    B065260E01
  1. Remove the screw.

  1. Using a heat light, heat the moulding to 40 to 60°C (104 to 140°F).

    NOTICE:
    Do not heat the moulding excessively.

  1. Disengage the 2 claws by pushing the moulding and remove the moulding.

    NOTICE:
    If reusing the moulding, take cake not to damage the moulding.



6. REMOVE REAR DOOR GLASS WEATHERSTRIP OUTER


    B062582E01
  1. Remove the screw.

  1. Put protective tape under the glass weatherstrip.

  1. Using a screwdriver or moulding remover, disengage the claw and remove glass weatherstrip.

    HINT:
    Tape the screwdriver tip before use.