PARK / NEUTRAL POSITION SWITCH > INSPECTION |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Jack up the vehicle.
Disconnect the park/neutral position switch connector.
Measure resistance according to the value(s) in the table below when the shift lever is moved to each position.
| Shift Position | Tester Connection | Specified Condition |
| P | 2 - 6 and 4 - 5 | Below 1 Ω |
| Except P | ↑ | 10 kΩ or higher |
| R | 1 - 2 | Below 1 Ω |
| Except R | ↑ | 10 kΩ or higher |
| N | 2 - 9 and 4 - 5 | Below 1 Ω |
| Except N | ↑ | 10 kΩ or higher |
| D and 4 | 2 - 7 | Below 1 Ω |
| Except D and 4 | ↑ | 10 kΩ or higher |
| 3 | 2 - 3 | Below 1 Ω |
| Except 3 | ↑ | 10 kΩ or higher |
| 2 and L | 2 - 8 | Below 1 Ω |
| Except 2 and L | ↑ | 10 kΩ or higher |