Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


    D028698E03
  1. Using SST and a hammer, carefully drive in a new oil seal in as far as will go.

    SST
    09316-60011   (09316-00011, 09316-00051)

    Oil seal depth from flat end:
    5.4 to 5.8 mm (0.213 to 0.228 in.)

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL PROPELLER SHAFT ASSEMBLY


    C098710E03
  1. Remove the SST from the extension housing.

    SST
    09325-40010  

  1. Install the propeller shaft assembly in the extension housing.



    C098711E02
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft assembly with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



3. ADD AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)



4. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
(Click here)