CYLINDER HEAD > INSPECTION |
| 1. CLEAN CYLINDER BLOCK SUB-ASSEMBLY |
![]() |
Turn the crankshaft, and bring each piston to the top dead center (TDC). Using a gasket scraper, remove all the carbon from the piston top surface.
![]() |
Using a gasket scraper, remove all the gasket material from the cylinder block surface.
Using compressed air, blow carbon and oil from the bolt holes.
| 2. CHECK CYLINDER BLOCK FOR WARPAGE |
![]() |
Inspect for warpage.
Using a precision straight edge and feeler gauge, measure the warpage of the contact surfaces of the cylinder head and crankshaft bearing cap.
![]() |
Visually check the cylinder for vertical scratches.
If deep scratches are present, rebore all the 8 cylinders and replace all the 8 pistons. If necessary, replace the cylinder block.
| 3. CLEAN CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Clean the cylinder head.
Using a gasket scraper, remove all the gasket material from the cylinder block contact surface.
![]() |
Using a wire brush, remove all the carbon from the combustion chambers.
![]() |
Using a valve guide bushing brush and solvent, clean all the guide bushes.
![]() |
Using a soft brush and solvent, thoroughly clean the cylinder head.
| 4. CHECK CYLINDER HEAD FOR WARPAGE |
![]() |
Inspect for warpage.
Using a precision straight edge and feeler gauge, measure the warpage of the contact surfaces of the cylinder block and the manifolds.
![]() |
Inspect for cracks.
Using a dye penetrant, check the combustion chamber, intake ports, exhaust ports and cylinder block surface for cracks.
If cracked, replace the cylinder head.
| 5. INSPECT CYLINDER HEAD SET BOLT |
![]() |
Using vernier calipers, measure the thread outside diameter of the bolt.