Home › ENGINE ยท 2UZ-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


    A004859E01
  1. Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-56010  



2. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY


    A134399E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A004869E03
  1. Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Part No. 08833-00070, THREE BOND 1324 or equivalent



    A004857E01
  1. Install the front spacer, drive plate and rear spacer on the crankshaft.

  1. Install and uniformly tighten the 8 mounting bolts in several steps, in the order shown in the illustration.

    Torque:
    30 N*m{ 301 kgf*cm , 22 ft.*lbf }

    If any one of the mounting bolts does not meet the torque specification, replace the mounting bolt.



    A087896E01
  1. Mark the mounting bolt with paint (Procedure "A").

  1. Retighten the mounting bolts by 90° in the order shown.

  1. Check that the painted mark is now at a 90° angle to the mark placed in procedure "A".



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)

HINT:



4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)

HINT: